Kevin O'Connor 0119e42d13 homing: Always start endstop checking before the nominal move start ...

Make sure the endstop checking is started prior to any movement.  This
helps ensure the verify_movement check is accurate.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-01-10 12:17:57 -05:00

..

chelper

winch: Add experimental support for cable winch kinematics

2018-12-24 11:38:59 -05:00

extras

controller_fan: Add support for a fan cooling the controller-board (#1070)

2019-01-10 12:12:15 -05:00

kinematics

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

clocksync.py

…

configfile.py

…

console.py

console: Try to improve the description of the SUPPRESS command

2018-11-16 17:16:14 -05:00

gcode.py

klippy: Convert printer_state("ready") to an event handler

2019-01-08 10:59:43 -05:00

heater.py

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

homing.py

homing: Always start endstop checking before the nominal move start

2019-01-10 12:17:57 -05:00

klippy.py

klippy: Fix error handling during connect phase

2019-01-08 13:46:26 -05:00

mathutil.py

…

mcu.py

klippy: Convert printer_state("connect") to an event handler

2019-01-08 11:09:55 -05:00

msgproto.py

…

parsedump.py

…

pins.py

sam3: Add support for sam4s8c chips

2019-01-07 19:34:31 -05:00

queuelogger.py

…

reactor.py

reactor: support for delayed callbacks

2019-01-07 21:38:36 -05:00

serialhdl.py

…

stepper.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

toolhead.py

klippy: Convert printer_state("shutdown") to an event handler

2019-01-08 10:59:43 -05:00

util.py

util: Fix versioning when gitdir is absent (#809)

2018-10-27 10:44:38 -04:00