Kevin O'Connor 1b1d3f15d8 probe: Fix PROBE_CALIBRATE command ...

The z_offset calculation should have been calculated from the probe
height to the measured bed position.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-03-08 12:34:13 -05:00

..

chelper

serialqueue: Wrap code to 80 columns

2019-02-27 14:20:15 -05:00

extras

probe: Fix PROBE_CALIBRATE command

2019-03-08 12:34:13 -05:00

kinematics

gcode: Change respond_info() to log by default

2019-03-04 13:04:18 -05:00

clocksync.py

clocksync: Wrap code to 80 columns

2019-02-27 13:01:52 -05:00

configfile.py

configfile: Strip trailing comments

2018-10-16 11:45:20 -04:00

console.py

console: Wrap code to 80 columns

2019-02-27 13:00:30 -05:00

gcode.py

gcode: Change respond_info() to log by default

2019-03-04 13:04:18 -05:00

heater.py

heater: Wrap code to 80 columns

2019-02-27 13:09:24 -05:00

homing.py

bltouch: Verify probe always deploys during a homing operation

2019-01-21 09:52:11 -05:00

klippy.py

klippy: Wrap code to 80 columns

2019-02-27 13:18:43 -05:00

mathutil.py

gcode: Change respond_info() to log by default

2019-03-04 13:04:18 -05:00

mcu.py

bltouch: Attempt to verify that the probe raises after each probe attempt

2019-01-21 09:52:11 -05:00

msgproto.py

msgproto: Wrap code to 80 columns

2019-02-27 13:06:15 -05:00

parsedump.py

build: Request python2 for all directly executed python binaries

2017-06-27 20:26:02 -04:00

pins.py

atsamd: Add definitions for SAMD21E18 chip

2019-03-01 19:05:00 -05:00

queuelogger.py

klippy: Automatically clear rollover_info on each restart

2018-04-03 13:18:52 -04:00

reactor.py

reactor: support for delayed callbacks

2019-01-07 21:38:36 -05:00

serialhdl.py

Revert "serialhdl: Enforce exclusive access on POSIX, this is default behavior on windows. (#1216)"

2019-02-10 11:57:02 -05:00

stepper.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

toolhead.py

gcode: Change respond_info() to log by default

2019-03-04 13:04:18 -05:00

util.py

util: Wrap code to 80 columns

2019-02-27 13:05:37 -05:00