Kevin O'Connor 24fe606d4d toolhead: Do not apply main printer accel/velocity to extrude only moves ...

Limit speed and acceleration of extrude only moves to just the
max_extrude_only_velocity and max_extrude_only_accel config settings.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-01-04 12:47:45 -05:00

..

chelper

winch: Add experimental support for cable winch kinematics

2018-12-24 11:38:59 -05:00

extras

thermistor: Avoid divide by zero error if min_temp=-273.15

2019-01-04 12:47:37 -05:00

kinematics

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

clocksync.py

clocksync: Simplify is_active() check

2018-05-31 18:20:30 -04:00

configfile.py

configfile: Strip trailing comments

2018-10-16 11:45:20 -04:00

console.py

console: Try to improve the description of the SUPPRESS command

2018-11-16 17:16:14 -05:00

gcode.py

respond: An extra for sending messages to the printer host. (#1053)

2019-01-02 17:45:35 -05:00

heater.py

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

homing.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

klippy.py

klippy: No need to return anything from _connect() method

2018-10-18 15:58:52 -04:00

mathutil.py

delta_calibrate: Perform coordinate descent in a background process

2018-10-15 19:01:19 -04:00

mcu.py

mcu: Allow set_stepper_kinematics() to set the kinematics back to None

2018-12-24 11:42:13 -05:00

msgproto.py

msgproto: Add support for a get_constant_int() method

2018-05-28 10:43:40 -04:00

parsedump.py

build: Request python2 for all directly executed python binaries

2017-06-27 20:26:02 -04:00

pins.py

bus: Don't raise a "duplicate pin" warning on None pins

2019-01-02 17:37:39 -05:00

queuelogger.py

klippy: Automatically clear rollover_info on each restart

2018-04-03 13:18:52 -04:00

reactor.py

reactor: Add ability to register callbacks

2018-06-30 14:13:47 -04:00

serialhdl.py

serialqueue: Limit message transmission to available receive buffer size

2018-05-28 11:12:30 -04:00

stepper.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

toolhead.py

toolhead: Do not apply main printer accel/velocity to extrude only moves

2019-01-04 12:47:45 -05:00

util.py

util: Fix versioning when gitdir is absent (#809)

2018-10-27 10:44:38 -04:00