Kevin O'Connor 2a8dd5c51f mcu: Reset the stepper step clock on init - not after each motor on ...

Reset the last step clock during the init phase and after each home -
this simplifies the runtime code.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2017-12-06 19:13:54 -05:00

..

cartesian.py

homing: Pass list of endstops (not steppers) to the homing code

2017-12-06 18:49:14 -05:00

chelper.py

…

chipmisc.py

gcode: Move SET_SERVO command from gcode.py to chipmisc.py

2017-12-06 18:35:51 -05:00

clocksync.py

clocksync: Start with adjusted_freq of 1.0

2017-10-13 21:07:32 -04:00

console.py

…

corexy.py

homing: Pass list of endstops (not steppers) to the homing code

2017-12-06 18:49:14 -05:00

delta.py

homing: Pass list of endstops (not steppers) to the homing code

2017-12-06 18:49:14 -05:00

extruder.py

stepper: Store pointers to step_const and step_delta in PrinterStepper

2017-11-18 17:29:23 -05:00

fan.py

fan: Enable heater_fan objects on an MCU shutdown event

2017-10-12 11:59:27 -04:00

gcode.py

gcode: Move SET_SERVO command from gcode.py to chipmisc.py

2017-12-06 18:35:51 -05:00

heater.py

heater: Avoid math errors on extreme ADC readings

2017-11-13 11:07:20 -05:00

homing.py

homing: Make sure to clean up homing state even if homing fails

2017-12-06 19:13:53 -05:00

klippy.py

gcode: Move SET_SERVO command from gcode.py to chipmisc.py

2017-12-06 18:35:51 -05:00

list.h

…

mcu.py

mcu: Reset the stepper step clock on init - not after each motor on

2017-12-06 19:13:54 -05:00

msgproto.py

…

parsedump.py

…

pins.py

pins: Add pin mapping for atmega1284p

2017-10-05 16:57:44 -04:00

pyhelper.c

…

pyhelper.h

…

queuelogger.py

…

reactor.py

…

serialhdl.py

serialhdl: Don't open port at 1200 baud

2017-10-12 21:46:09 -04:00

serialqueue.c

serialqueue: Don't report sent_time on responses that are retransmitted

2017-09-30 19:37:20 -04:00

serialqueue.h

…

stepcompress.c

stepcompress: Fix proactive queue flushing on move with 64K+ steps

2017-11-29 20:24:50 -05:00

stepper.py

mcu: Reset the stepper step clock on init - not after each motor on

2017-12-06 19:13:54 -05:00

toolhead.py

gcode: Simplify exception handling

2017-12-06 18:35:51 -05:00

util.py

…