Kevin O'Connor 3b6ddb08a1 bltouch: Don't error on startup if the bltouch is in an error state ...

Stopping the connect sequence can make it difficult to get the bltouch
out of an error state.  Allow the connect to proceed, ideally if the
bltouch stays in an error state it will be detected during the first
probe attempt.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-01-31 09:43:35 -05:00

..

chelper

…

extras

bltouch: Don't error on startup if the bltouch is in an error state

2019-01-31 09:43:35 -05:00

kinematics

…

clocksync.py

…

configfile.py

…

console.py

…

gcode.py

gcode: add 'speed' parameter to dictionary returned by get_status()

2019-01-28 11:23:52 -05:00

heater.py

…

homing.py

bltouch: Verify probe always deploys during a homing operation

2019-01-21 09:52:11 -05:00

klippy.py

klippy: Report the first error generated

2019-01-11 12:41:55 -05:00

mathutil.py

…

mcu.py

bltouch: Attempt to verify that the probe raises after each probe attempt

2019-01-21 09:52:11 -05:00

msgproto.py

…

parsedump.py

…

pins.py

atsamd: Initial support for SAMD51

2019-01-28 20:02:16 -05:00

queuelogger.py

…

reactor.py

reactor: support for delayed callbacks

2019-01-07 21:38:36 -05:00

serialhdl.py

…

stepper.py

…

toolhead.py

klippy: Convert printer_state("shutdown") to an event handler

2019-01-08 10:59:43 -05:00

util.py

util: Don't crash when calling get_cpu_info on OS X (#1102)

2019-01-11 13:00:44 -05:00