Kevin O'Connor 40e2c64c82 clocksync: Fix typo in pause() call at connect time ...

The initial clock measurement wasn't properly implementing a small
delay between clock queries.  Fix the pause() call so there is a small
delay between queries.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-10-31 11:36:35 -04:00

..

chelper

…

extras

tmc_uart: Don't try to configure analog pins to -1 value

2019-10-26 11:33:30 -04:00

kinematics

kinematics: Add get_status() method to kinematics

2019-08-09 20:49:17 -04:00

clocksync.py

clocksync: Fix typo in pause() call at connect time

2019-10-31 11:36:35 -04:00

configfile.py

configfile: Fix the exception raised when an included file is missing (#1931)

2019-09-01 18:28:18 -04:00

console.py

console: Update for PinResolver changes

2019-08-19 23:52:02 -04:00

gcode.py

gcode: Allow M105 to produce output if called from a macro

2019-09-18 09:58:16 -04:00

heater.py

…

homing.py

homing: Remove no longer needed homing time delay code

2019-07-10 10:43:20 -04:00

klippy.py

klippy: Warn if starting klippy with logging disabled

2019-09-01 18:09:20 -04:00

mathutil.py

gcode: Change respond_info() to log by default

2019-03-04 13:04:18 -05:00

mcu.py

mcu: Prevent "math domain errors" in stats calculation

2019-08-30 13:57:07 -04:00

msgproto.py

bus: Support bus enumerations and add support for reserved pins

2019-04-04 18:29:31 -04:00

parsedump.py

build: Request python2 for all directly executed python binaries

2017-06-27 20:26:02 -04:00

pins.py

board_pins: Add a new "extras" module to support per-board pin aliases

2019-08-19 12:57:59 -04:00

queuelogger.py

klippy: Automatically clear rollover_info on each restart

2018-04-03 13:18:52 -04:00

reactor.py

reactor: Add support for "completions"

2019-07-10 10:43:20 -04:00

serialhdl.py

serialhdl: Update SendWithRetry to use reactor completions

2019-07-10 10:43:20 -04:00

stepper.py

stepper: Add support for providing a list of pins to enable

2019-06-28 16:59:26 -04:00

toolhead.py

tuning_tower: Tool for tuning parameters based on print Z height

2019-10-01 14:46:24 -04:00

util.py

util: Ignore errors in clear_hupcl (allows OSX to run)

2019-05-20 16:49:42 -04:00