Kevin O'Connor 4c48c1e8e4 bltouch: Issue just a pin_up command on a normal raise probe attempt ...

In the normal case, a regular pin_up command should be sufficient to
raise the probe.  (Should the regular pin_up fail, the code can issue
a "reset" command during the retry.)

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2019-02-04 18:03:07 -05:00

..

chelper

winch: Add experimental support for cable winch kinematics

2018-12-24 11:38:59 -05:00

extras

bltouch: Issue just a pin_up command on a normal raise probe attempt

2019-02-04 18:03:07 -05:00

kinematics

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

clocksync.py

clocksync: Simplify is_active() check

2018-05-31 18:20:30 -04:00

configfile.py

configfile: Strip trailing comments

2018-10-16 11:45:20 -04:00

console.py

console: Try to improve the description of the SUPPRESS command

2018-11-16 17:16:14 -05:00

gcode.py

gcode: add 'speed' parameter to dictionary returned by get_status()

2019-01-28 11:23:52 -05:00

heater.py

heater: take a gcode_id when setting up a heater (#1028)

2019-01-02 17:44:02 -05:00

homing.py

bltouch: Verify probe always deploys during a homing operation

2019-01-21 09:52:11 -05:00

klippy.py

klippy: Report the first error generated

2019-01-11 12:41:55 -05:00

mathutil.py

delta_calibrate: Perform coordinate descent in a background process

2018-10-15 19:01:19 -04:00

mcu.py

bltouch: Attempt to verify that the probe raises after each probe attempt

2019-01-21 09:52:11 -05:00

msgproto.py

msgproto: Add support for a get_constant_int() method

2018-05-28 10:43:40 -04:00

parsedump.py

…

pins.py

atsamd: Initial support for SAMD51

2019-01-28 20:02:16 -05:00

queuelogger.py

…

reactor.py

reactor: support for delayed callbacks

2019-01-07 21:38:36 -05:00

serialhdl.py

serialqueue: Limit message transmission to available receive buffer size

2018-05-28 11:12:30 -04:00

stepper.py

endstop_phase: Move endstop phase homing code to new "extras" module

2018-10-16 13:09:23 -04:00

toolhead.py

klippy: Convert printer_state("shutdown") to an event handler

2019-01-08 10:59:43 -05:00

util.py

util: Don't crash when calling get_cpu_info on OS X (#1102)

2019-01-11 13:00:44 -05:00