5d26c2a08e
This reverts commit 43fa41c1af648ea626040e17f0eebda39dcdb2cb. The above commit disabled absolute extrude moves because it was unclear if the code would work properly when an M221 extrude factor or G92 offset was in use. However, since the calculation is done relative to the raw E position and is sent as a raw E position to gcode.cmd_G1() these modes should not matter. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation.