CreatBotKlipper

Go to file

Kevin O'Connor 77bc5e4388 stepper: Improve get_past_commanded_position()

Pass a print_time instead of a clock to get_past_commanded_position().
Fix calculation on steppers that home and use an inverted direction
pin.

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

2021-05-29 21:29:00 -04:00

.github

workflows: Minor wording change to invalid-label-bot

2021-05-17 10:31:03 -04:00

config

config: Change current scale on generic-ultimaker-ultimainboard-v2.cfg

2021-05-28 18:56:33 -04:00

docs

docs: Fix malformed link in beaglebone.md

2021-05-29 15:09:43 -04:00

klippy

stepper: Improve get_past_commanded_position()

2021-05-29 21:29:00 -04:00

lib

lpc176x: Use full peripheral clock speed; fix UART interface

2021-05-04 20:29:48 -04:00

scripts

spi_flash: Add board definitions for Fysetc S6 and Spider

2021-05-03 14:36:18 -04:00

src

Revert "linux: Raise an error if configuring a pullup when that is not supported"

2021-05-27 11:33:24 -04:00

test

loop_sdcard: Add loopable SD card file sections

2021-05-26 11:57:57 -04:00

.gitignore

util: Fix versioning when gitdir is absent (#809 )

2018-10-27 10:44:38 -04:00

COPYING

Initial commit of source code.

2016-05-25 11:37:40 -04:00

Makefile

Makefile: Use CURDIR instead of PWD

2021-05-19 23:49:50 -04:00

README.md

docs: Update main README file to point to website

2019-04-20 13:43:35 -04:00

README.md

Welcome to the Klipper project!

https://www.klipper3d.org/

Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.

To begin using Klipper start by installing it.

Klipper is Free Software. See the license or read the documentation.