b0b950b7e1
Also applies to the Monoprice Maker Pro MK1. This config is based on the version from Chris Barnes (https://www.facebook.com/Jarannis) found on https://pastebin.com/raw/wm8PQezy. This config was mostly working and I only had to change a few things: - updated key names for min_point and max_point to mesh_min and mesh_max - enabled PID control - tweaked bounds to allow movement during mesh leveling - removed all comments - decreased homing speed slightly - sane bed mesh sample defaults In response to Kevin O'Connor: - remove pressure_advance setting from extruder section - remove respond section - remove pause_resume section Signed-off-by: Matt Shirley <mdshw5@gmail.com>
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation.