d6b69938ab
The SET_GCODE_OFFSET command could cause unwanted behavior when an offset is applied to the following g-code command. (In particular, when the following command is an extrude only move - as in issue #1289.) Don't apply the offset immediately. Instead, add support for a MOVE=1 parameter which will schedule a move to apply the given offset. Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Welcome to the Klipper project!
Klipper is a 3d-Printer firmware. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use Klipper.
To begin using Klipper start by installing it.
Klipper is Free Software. See the license or read the documentation.