edc3d34beb
With the introduction of "scanning" probes it has become common for configurations to generate a large number of points. This can overwhelm both the log and the pty when new points are generated. This patch limits the initial points logged to 50. In addition points are no longer logged or pushed over the pty when the mesh configuration changes. Signed-off-by: Eric Callahan <arksine.code@gmail.com>
Welcome to the Klipper project!
The Klipper firmware controls 3d-Printers. It combines the power of a general purpose computer with one or more micro-controllers. See the features document for more information on why you should use the Klipper software.
Start by installing Klipper software.
Klipper software is Free Software. See the license or read the documentation. We depend on the generous support from our sponsors.