diff --git a/docs/panels.md b/docs/panels.md
index 58b84b9f..33755e16 100644
--- a/docs/panels.md
+++ b/docs/panels.md
@@ -26,6 +26,19 @@
 type: bed_level
 ![Bed Level](img/bedlevel.png)
 
+The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following
+Klipper Sections:
+* [bed_screws](https://github.com/KevinOConnor/klipper/blob/master/docs/Config_Reference.md#bed_screws)
+* [screws_tilt_adjust](https://github.com/KevinOConnor/klipper/blob/master/docs/Config_Reference.md#screws_tilt_adjust)
+
+_Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled_
+_KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used._
+
+This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button
+for _Screws Calibrate_ will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the
+panel.
+
+
 ### Extrude
 type: extrude
 ![Extrude](img/extrude.png)