# Panels ### Main Menu  ### Job Status ```py panel: job_status ```  ### Bed Level ```py panel: bed_level ```  The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following Klipper Sections: * [bed_screws](https://www.klipper3d.org/Config_Reference.html#bed_screws) * [screws_tilt_adjust](https://www.klipper3d.org/Config_Reference.html#screws_tilt_adjust) _Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled_ _KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used._ This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button for _Screws Calibrate_ will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the panel. ### Bed Mesh ```py panel: bed_mesh ```  ### Extrude ```py panel: extrude theme:material-dark ```  ### Fan ```py panel: fan ```  ### Fine Tune ```py panel: fine_tune ```  ### Gcode Macros ```py panel: gcode_macros ```  ### Menu  ### Move ```py panel: move ```  ### Network ```py panel: network ```  ### Power ```py panel: power ```  ### Print ```py panel: print ```  ### Settings ```py panel: settings ```  ### System ```py panel: system ```  ### Temperature ```py panel: temperature ```  ### Z Calibrate ```py panel: zcalibrate ```  ### Limits ```py panel: limits ```  ### Retraction ```py panel: retraction ```  ### Input Shapers ```py panel: input_shaper ``` 