Klipper now has the ability to report the current layer on
properly configured slicers. Prefer this value if available,
otherwise fall back to layer detection.
Signed-off-by: Eric Callahan <arksine.code@gmail.com>
Users may specify a dedicated ambient sensor in the
[simplyprint] configuration. If the specified sensor is
invalid or no sensor is specified ambient detection
will fall back to an estimate using the extruder.
Signed-off-by: Eric Callahan <arksine.code@gmail.com>
Its possible for the websocket client to disconnect before
read_message() returns None. Await all calls to write_message()
to handle websocket closed exceptions.
Signed-off-by: Eric Callahan <arksine.code@gmail.com>
This adds initial support for connecting Moonraker to the SimplyPrint
service. Currently the connection defaults to SimplyPrint's dev/test
endpoint, this will be changed prior to official release.
Signed-off-by: Eric Callahan <arksine.code@gmail.com>