It appears there was a security vulnerability in Jinja v3.1.4 . The
Klipper docs are not impacted by this vulnerability, but it's simple
enough to increment the version to avoid warnings.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
If the low-level canbus stops working then it could become impossible
to send messages to and from the canbus bridge node itself. This can
make it difficult to diagnose canbus problems.
Change the canbus bridge code to detect if message transmits become
stalled for 50+ milliseconds and go into a "discarding" state. In
this discarding state, messages destined for the canbus will be
discarded until the canbus becomes active again. In this discarding
state it will therefore be possible to transmit messages to and from
the canbus bridge node.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Add support for a new get_canbus_status command to canserial.c .
Add new canbus_stats.py module that will periodically query canbus
mcus for connection status information.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
This significantly reduces the amount of data in the generation 2 garbage collection bucket from the initial startup of klipper.
Signed-off-by: Branden Cash <203336+ammmze@users.noreply.github.com>
Added a temperature sensor configuration for ADS1103, ADS1104, ADS1105, ADS1113, ADS1114 and ADS1115 chips that can be used to add Analog to Digital Conversion capability to machines that don't have that on their own. Like Raspberry Pi's or if more analog input pins are needed than the chip provides like for RP2040. Generally they can be used for any analog input, but the typical use case is for temperature measurement. This code also has been written with temperature measurement in mind and not as a general ADC.
Signed-off-by: Konstantin Koch <korsarnek@gmail.com>
Signed-off-by: Jack Wakefield <jackwakefield@protonmail.com>
Pass a string such as "xyz" to kin.clear_homing_state(). This makes
the parameter a little less cryptic.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Use strings such as "xyz" to specify which axes are to be considered
homing during a set_position() call. This makes the parameter a
little less cryptic.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Call clear_homing_state() on each motor off event. This simplifies
the kinematic classes as they no longer need to register and handle
the motor_off event.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Update the heating code to periodically check that the main thread is
operating properly. This is a mitigation for some rare cases where
the main thread may lockup while the background heater updating code
continues to run. The goal is to detect these rare failures and
disable future heater updates.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
`CLEAR` clears the homing status (resets the axis limits) without turning off
the motors. This is particularly useful when implementing safe Z homing in
`[homing_override]` on printers with multiple independent Z steppers (where
`FORCE_MOVE` can't be used).
Signed-off-by: Dennis Marttinen <twelho@welho.tech>
