1.9 KiB
Panels
Index
- Main menu
- Job Status
- bed_level
- extrude
- fan
- fine_tune
- move
- network
- preheat
- system
- temperature
- zcalibrate
Main Menu
Job Status
Bed Level
type: bed_level
The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following Klipper Sections:
Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used.
This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button for Screws Calibrate will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the panel.
Extrude
type: extrude
Fan
type: fan
Fine Tune
type: fine_tune
Menu
type: menu
Move
type: move
Network
type: network
Preheat
type: preheat
type: print
System
type: system
Temperature
type: temperature
Z Calibrate
type: zcalibrate
