1.8 KiB
Panels
Main Menu
Job Status
Bed Level
type: bed_level
The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following Klipper Sections:
Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used.
This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button for Screws Calibrate will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the panel.
Bed Mesh
type: bed_mesh
Extrude
type: extrude
Fan
type: fan
Fine Tune
type: fine_tune
Gcode Macros
type: gcode_macros
Menu
type: menu
Move
type: move
Network
type: network
Power
type: power
Preheat
type: preheat
type: print
Settings
type: settings
System
type: system
Temperature
type: temperature
Z Calibrate
type: zcalibrate
