2.1 KiB
2.1 KiB
Panels
Main Menu
Job Status
panel: job_status
Bed Level
panel: bed_level
The bed level panel has the ability to have preset locations from Klipper. Please see documentation on the following Klipper Sections:
Important Note: Due to Klipper using the bltouch/probe offsets in screws_tilt_adjust, if a bltouch/probe is enabled KlipperScreen will add the offset to the defined screw values. This will not occur if bed_screws section is used.
This panel will favor screws_tilt_adjust over the bed_screws section. If screws_tilt_adjust is defined, an extra button for Screws Calibrate will appear. This button runs the SCREWS_TILT_CALCULATE command and shows the results on the panel.
Bed Mesh
panel: bed_mesh
Extrude
panel: extrude theme:material-dark
Fan
panel: fan
Fine Tune
panel: fine_tune
Gcode Macros
panel: gcode_macros
Menu
Move
panel: move
Network
panel: network
Power
panel: power
panel: print
Settings
panel: settings
System
panel: system
Temperature
panel: temperature
Z Calibrate
panel: zcalibrate
Limits
panel: limits
